ShenzhenCutting machineCutting machineDirect Selling of ProductionTianjin AD Automation Company is a manufacturer of industrial electrical automation and mechanical automation equipment. Since its establishment, it has been adhering to reasonable, challenging and pioneering business philosophy, devoted to the successful enterprise concept of customers, constantly innovating independently and developing various types of automation equipment.It is necessary to check the sealing ring of turbocharger frequently. Because if the seal ring is not sealed, the exhaust gas will enter the engine lubrication system through the seal ring, which will dirty the oil and make the crankcase pressure rise rapidly. In addition, when the engine runs at low speed, the oil will be discharged from the exhaust pipe or burned into the combustion chamber through the seal ring, resulting in excessive oil consumption.“ Burning oil. Turbochargers should always check for abnormal noise or vibration, and for leakage of lubricating oil pipes and joints. Turbocharger rotor bearings have high precision and strict working environment during maintenance and installation. Therefore, when the turbocharger fails or is damaged, it should be repaired at the designated maintenance station rather than at the general repair shop. In order to keep the air filter clean, turbocharged engines require higher cleaning requirements than ordinary engines. If impurities enter the compressor impeller, it will cause unstable speed or worn axle sleeve and seal parts. The engine oil should be kept clean, and the turbocharged engine has a high requirement for engine oil, so it must be kept clean. In addition, the deterioration of fruit oil should be replaced in time. Otherwise, the lubrication ability of oil will decrease, which will cause insufficient lubrication of turbocharger bearings and damage, increase maintenance costs, and even cause premature scrapping of turbocharger. It is not good for turbocharged engine to start and go off immediately. It is better for engine to idle for a while after starting, so that lubricating oil can lubricate bearings sufficiently and play a very good protective role for engine. In addition, the engine should idle for 3-5 minutes after a long period of high-speed operation, otherwise, the remaining oil in the turbocharger will overheat and damage the bearings and shafts.